If you like EZ Mount then you are going to love this! U-MOUNT repositional cushioning is manufactured right here in the UK and is the perfect solution for mounting your unmounted rubber stamps.

Measuring 210mm x 230mm (A4) U-Mount fits 2 of our A5 sized sets perfectly, with a little room to spare!

Instructions
1) Cut your chosen stamp design with a sharp pair of scissors. Do not trim too close to the die (the stamp design) as the image will not print properly.

2) Cut a piece of U-MOUNT slightly larger than the die, peel paper away from the sticky side of the cushion and press die onto it.

3) Cut the stamp design out with a sharp pair of scissors, remembering to leave a border of a few millimeters. It is essentail that you do not undercut the die. The cut should slope away from the die, so that the die receives even pressure when stamped.

4) Peel paper from the U-MOUNT side of the cushion and press the design firmly onto your choice of acrylic block.

5) Ink up the image and stamp your design as normal. When finished, clean your stamp, taking care not to get water on the U-MOUNT.